Back to Rulon®
Rulon® 123 is a glossy black non-abrasive compound for softer mating surfaces, such as stainless steel. This material has excellent chemical resistance and is FDA, USDA, and NSF compliant. It is less expensive than Rulon J but is slightly less flexible and higher in wear. It has a high resistance to deformation, a low coefficient of friction, and good thermal and electrostatic dissipation. This material has a maximum operating temperature of 550˚F(300˚C).
Notable Material Features
- High compression strength
- Low coefficient of friction
- Excellent abrasion and corrosion resistance while running without lubrication
Grades of Rulon®
| Rulon LR Properties | |
|---|---|
| Temperature – Typical Range ËšF (ËšC ) | -400/+550 (-240/288)* |
| Maximum PV (continuous)(MPa+m/s) | 10,000 (0.35)* |
| Maximum P – psi (static)(MPa) | 1,000 (6.9)* |
| Maximum V -SFM (no load)(m/s) | 400 (2)* |
| ShaftHardness – Minimum | Rb25 |
| Shaftfinish recommended Ra (min/um) | 8 – 16 (0.2-0.4)* |
| ShaftMaterial | Steel |
| Products | Applications |
|---|---|
| Automatically molded bearings & components | Pumps |
| Sleeve,flanged and thrust bearings | Mixers |
| Piston Rings | Compressors |
| Stamped and formed seals | Appliances |
| Extruded shapes | Automotive Lips Seals |
| Machined parts | Linear Slides |
| Molded shapes | Pipe Supports |
| Wear Bands |
| Engineering | |
|---|---|
| Friction – static & dynamic | .10 – .30 |
| Water Absorption ASTM D570 | 0% |
| Flammability ASTM D635 | Non-Flammable |
| Chemical Resistance | Inert |
| Thermal Conductivity | 4.6 |
| BTU/hr/sq.ft./ËšF/in. | 4.6 |
| Linear Coefficientof (78Ëš-200ËšF) | Diameter 4.4×10-5 (7.9)* |
| Thermal Expansion (26Ëš -93ËšC) | Length 7.0×10-5 (12.6)* |
| Physical Data | |
|---|---|
| Elongation ASTM D638 | 150% |
| Tensile Strength ASTm D638 (MPa) | 2500 PSI (17.2)* |
| Deformation (1500 psi – 24 hr. RT) | 2.5% |
| Specific Gravity | 2.12 |
Rulon® is a registered trademark of Saint-Gobain Performance Plastics Corporation.